![...](/img/main_bg8.jpg)
更新情報
第16回
ITERにおける核融合炉の保守保全技術の進展
著者:
武田 信和,野口 悠人,丸山 孝仁,齋藤 真貴子,(量研機構)
発刊日:
公開日:
キーワードタグ:
Blanket Fusion Reactor ITER Manipulator Remote Maintenance Robot Arm
武田 信和,野口 悠人,丸山 孝仁,齋藤 真貴子,(量研機構)
発刊日:
公開日:
キーワードタグ:
Blanket Fusion Reactor ITER Manipulator Remote Maintenance Robot Arm
It is considered that most of maintenance operation of fusion reactors will be performed remotely because of high gamma-ray radiation inside the reactor. The ITER, an experimental fusion device constructed under the international collaboration, will test and confirm such remote maintenance technologies to realize remote maintenance in the DEMO reactors planned for demonstration of fusion energy. This report outlines remote maintenance technology of the ITER....
英字タイトル:
Progress of Maintenance Technology of Fusion Reactor for ITER
英字タイトル:
Progress of Maintenance Technology of Fusion Reactor for ITER
第17回
放射光X線を用いたアルミニウム単結晶の 変形・再結晶中のその場観察
著者:
城 鮎美,(量研機構),菖蒲 敬久,(JAEA),岡田 達也,(徳島大)
発刊日:
公開日:
キーワードタグ:
Aluminum Deformation In-Situ Observation Recrystallization Single Crystal
城 鮎美,(量研機構),菖蒲 敬久,(JAEA),岡田 達也,(徳島大)
発刊日:
公開日:
キーワードタグ:
Aluminum Deformation In-Situ Observation Recrystallization Single Crystal
Deformation and recrystallization mechanisms are worthy of a note as the controls in properties of metallic materials. In this study, deformation and recrystallization of aluminum single crystal were in-situ observed using synchrotron X-rays, and the recrystallization behavior was obtained. The specimen was deformed with plastic strain of 8 %, and was heated at 753 K. after 6 minutes from heating, the diffraction from subgrains were appeared in the diffraction pattern of the initial crystal. The subgrains c...
英字タイトル:
In-situ Observation during Deformation and Recrystallization of Aluminum Single Crystal using Synchrotron Radiation
英字タイトル:
In-situ Observation during Deformation and Recrystallization of Aluminum Single Crystal using Synchrotron Radiation
第16回
核融合の規格基準整備に向けた活動の状況
著者:
角舘 聡,宇藤 裕康,中嶋 秀夫,(量研機構)
発刊日:
公開日:
キーワードタグ:
Fusion Demo Reactor Mechanical Engineers Code Structural Integrity
角舘 聡,宇藤 裕康,中嶋 秀夫,(量研機構)
発刊日:
公開日:
キーワードタグ:
Fusion Demo Reactor Mechanical Engineers Code Structural Integrity
Maintenance of the fusion Demo reactor will be done to maintain structural Integrity and continuous operation over lifetime of reactor. In order to maintain the required performance of vacuum vessel, breeding blankets and cooling pipe, it is necessary to ensure maintenance technology for supporting the structural Integrity such as in-service inspection, repair, replacement, and maintenance activities based on evaluations for each of components. Current Status and future plan related to development of mechan...
英字タイトル:
Current Status related to development of Mechanical Engineers Code for Fusion Facilities
英字タイトル:
Current Status related to development of Mechanical Engineers Code for Fusion Facilities
第16回
核融合原型炉における保守保全の考え方と課題
著者:
染谷 洋二,角舘 聡,宇藤 裕康,日渡 良爾,坂本 宜照,飛田 健次,(量研機構),原型炉設計合同特別チーム
発刊日:
公開日:
キーワードタグ:
Fusion DEMO plant Maintenance Preservation Water activation
染谷 洋二,角舘 聡,宇藤 裕康,日渡 良爾,坂本 宜照,飛田 健次,(量研機構),原型炉設計合同特別チーム
発刊日:
公開日:
キーワードタグ:
Fusion DEMO plant Maintenance Preservation Water activation
In-vessel components (IVCs) such as blanket segments and divertor cassettes strongly receive neutron irradiation through high energy neutron (14.06 MeV) from fusion plasma. Therefore, a fusion DEMO plant requires a periodic replacement of IVCs. The dose rate of IVCs for DEMO is one order of magnitude higher than that for ITER. The JA DEMO also requires a five-year cooling time to reduce its dose rate to the level of ITER's dose rate. The maintenance scheme for DEMO requires the components to be replaced by ...
英字タイトル:
Opinion of the maintenance and preservation for a fusion DEMO reactor
英字タイトル:
Opinion of the maintenance and preservation for a fusion DEMO reactor
第17回
核融合原型炉ブランケット冷却管渦電流探傷試験における プローブ方式によるきず検出性能比較
著者:
加子 瑞騎,葛玖 浩,冨澤 拓真,(東北大),野澤 貴史,(量研機構),遊佐 訓孝,(東北大)
発刊日:
公開日:
キーワードタグ:
ECT Ferromagnetic Fusion reactor RAFM SN ratio
加子 瑞騎,葛玖 浩,冨澤 拓真,(東北大),野澤 貴史,(量研機構),遊佐 訓孝,(東北大)
発刊日:
公開日:
キーワードタグ:
ECT Ferromagnetic Fusion reactor RAFM SN ratio
This study investigated the influence of probe types on the detection capability of eddy current testing technique against the flaws on F82H steel. Three surface slits were fabricated in F82H specimens with a thickness of 10 mm. The slit depth is 0.5, 1, and 3 mm. The slits were detected by pancake probe, vertical pancake probe, uniform probe, and plus point probe. The signal to noise ratio of used probes was calculated and compared. The greatest signal to noise ratio was plus point probe, followed in order...
英字タイトル:
Influence of probe types on detection capability of eddy current testing to blanket cooling tube of fusion prototype reactor
英字タイトル:
Influence of probe types on detection capability of eddy current testing to blanket cooling tube of fusion prototype reactor
第16回
核融合炉の保全技術確立に向けた開発計画
著者:
岡野 邦彦,(ODAC),笠田 竜太,(東北大),飛田 健次,(量研機構)
発刊日:
公開日:
キーワードタグ:
A-FNS Ferritic Steel Fusion Materials Fusion Regulation Neutron Source Roadmap Tokamak
岡野 邦彦,(ODAC),笠田 竜太,(東北大),飛田 健次,(量研機構)
発刊日:
公開日:
キーワードタグ:
A-FNS Ferritic Steel Fusion Materials Fusion Regulation Neutron Source Roadmap Tokamak
A core machine in the present state of the fusion energy development is ITER. In the next step, of which the goal is net electric power generation with an acceptable availability, the core machine is a DEMO reactor and the plan towards it is drawn up by the committee of the MEXT. The action plan towards the DEMO is composed of 12 issues and two issues of them are related to the maintenance technology. In this paper, we are briefly reviewing those issues in the action plan....
英字タイトル:
Action Plan towards Establishment of Maintenance Technology for Fusion Reactors
英字タイトル:
Action Plan towards Establishment of Maintenance Technology for Fusion Reactors
第17回
高エネルギー放射光によるオーステナイト系ステンレス鋼の応力測定
著者:
鈴木 賢治,(新潟大),城 鮎美,(量研機構),菖蒲 敬久,(JAEA),豊川 秀訓, 佐治 超爾,(JASRI)
発刊日:
公開日:
キーワードタグ:
Austenitic Stainless Steel CCD Camera CdTe Pixel Detector Double Exposure Method Hard Synchrotron X-rays X-Ray Stress Measurement
鈴木 賢治,(新潟大),城 鮎美,(量研機構),菖蒲 敬久,(JAEA),豊川 秀訓, 佐治 超爾,(JASRI)
発刊日:
公開日:
キーワードタグ:
Austenitic Stainless Steel CCD Camera CdTe Pixel Detector Double Exposure Method Hard Synchrotron X-rays X-Ray Stress Measurement
In this study, stress measurements were performed using a double exposure method with hard synchrotron monochromatic X-rays, and its validity was proved. The diffractions of the shrink-?tted ring of austenitic stainless steel SUS304 were measured by the CdTe pixel detector. The used X-rays were 70, 80 and 90 keV. The measured stress distributions with the 311 diffraction of γ-Fe corresponded to the predicted result. In addition, The stress distribution of the shrink-?tted ring was measured by the CCD camera...
英字タイトル:
Stress Measurements of Austenitic Stainless Steel using Hard Synchrotron X-Rays
英字タイトル:
Stress Measurements of Austenitic Stainless Steel using Hard Synchrotron X-Rays